System freezes with AmigaOS 4.1 FE with Radeon 9200 PCI gfx board

Hi Amiga lovers!

I have aproblem with AmigaOS 4.1FE.
I have a SAM440ep with a Radeon 9200 PCI gfx card.
With update 6 everything ran fine.

My system freezes after loading the Wb Screen

This is what I could figure out so far - but now I am lost..

I commented LoadMonDrvs out in startup-sequence.
Then the system starts with boot sound an everything else.
I looked into the screenmodes and there are only the lower vga modes listed.
That's ok because of not loading the drivers.

I can now open a shell and load the drivers with the command 'LoadMonDrvs'
That goes well and system still running ok.
Now when I go back to screenmode prefs van see all modes available up to 1920x1080

If I say 'test the mode 1920x1080' the mode switches to this resolution and shows the test pic
and the dialog saying 'if mode is ok click ok to save' . But this is it
System freezes completely - cannot even move the mouse anymore nor save the mode.

But I recognized two issues: My gfx board is named Board-0. Up to update 6 it was always named Radeon 9200 SE.
Second is in devs/montitors. I only can see a Monitor named NONE with almost anything disabled in the information tab. I tried to do auto-reconize monitor but this didn't help.

Have you any further ideas!

Thanx so much!

Andi

Already answered on AW, can't be bothered to reply properly here too.

@Severin
Yes, I must say that it's deeply irritating when people do this.


@fastbit66
If you're posting a message to ask for help with problems, post your message to the first forum and show a little patience to WAIT for a response. If you receive no response in a reasonable amount of time, THEN go ahead and post to another forum.

Posting the same message to multiple forums at the same time just serves to waste people's time.