peg2 firmware and os4_command line

Maybe someone can help me to understand what i do wrong:

We have 2 ways to setup what to redirect to serial outputs: kdebug utility and firmware. With kdebug all works for me fine, but i can't make it works from peg2's firmware/os4-bootloader.

The os4 bootloader have variable (the same for all firmwares as i know): os4_commandline.

All what i want now, its pass to "os4_commandline" variable those values: "serial" "munge" and "debug level X" values at one time.

For first, i just tryed with only "serial". So far i tried like this and it didn't works for me:

Quote:

and

Quote:

and

Quote:

and

Quote:

And all the same but with adding "console" before serial too. none of them seems to works, and only when i use kdebug from shell like

Quote:

It start to works, but for my own reasons i need to set it all from via bootloader's os4_commandline variable, and not via kdebug (don't ask why, just need it like that).

I know that on x1000 it is like this:

Quote:

So without quates, just big letters via space between values.

And know that for uboots its like:

Quote:

I.e. just with quotes.

But how it should be for peg2 and how to make it works now..

Just an observation, and it may be red herring, but everyone of your commandlines you shown has a stray " at the end, if that is really there then perhaps it is messing something up?

@Andy
They should be at beginning and end of strings with one space to make it works (i just copy + paste without first " ).

There is my full bootmenu.txt.

Line #30 is load amigaboot.of and pass os4_commandline to it. The way as it now in my config it just didn't works, and serial logging for me start to works only when i use kdebug.

I even grep amigaboot.of in hex editor: it have os4_commandline string, so it here and should work, just seems need to pass params somehow different .. How it done on SAM/uboot if you want for example to set "serial+munge+debuglevel7" ?