@AmigaSociety
Nice vid!
You should also check out your "Power" pref. This preference tool allows you to switch the card between high and low power mode. High Power means more performance.
My setting is saved to High power mode. But for some reason, it fails to apply High power mode after a reboot.
Kas1e came up with a fix by forcing the Power pref to run once after reboot with adding the following line to the the user-startup:
; Make sure that RX power mode is always applied on a boot
Run >NIL: *>NIL: sys:Prefs/Power QUIET
It looks like your power pref is set a low.
I can run the same voxel edges at 120-200 fps in the preview window (vsync disabled). And about 20pfs fullscreen
My personal favourite shader is multipass->Full screen radial blurr. This one runs at ~80fps in full screen mode.
Edited by geennaam on 2023/12/3 10:13:52